K11 Owners Group

That has been one of the most meaningful sequential posts I've read anywhere, capturing the spirit of the ride with all its many facets. Thanks so much.

O Brasil, minha soldade.

Oh my! Thanks so much for the pics and please keep them coming.

Have you taken the KLT to Parana or Santa Catarina?

It is not a switch on K11, it provides a precise angular position to the motronic.
Here is how to set it up: http://www.largiader.com/articles/motronic.html
For full sync: throttle body sync[/quote] ...

What is the correct method of setting the switch on K1100s?

Thanks for your response(s).

Thanks Jeff

Your comment may be correct, however, I've equated slight advance with added performance, not retard. I'll certainly post my "unofficial" results in a week or so. I'm putt ...

Removing the oil filter cover is something I do most of the time, however, I have a magnetic drain plug and every third change I remove it and collect any of the ferrous particles on it -- there alw ...

Removing the oil filter cover is something I do most of the time, however, I have a magnetic drain plug and every third change I remove it and collect any of the ferrous particles on it -- there alw ...

Thanks for the viewpoints expressed. I suspect a good solution would be to make a dyno run at factory spec and with a two degree added advance. That might be expensive and leaves me with a "s ...

If there are archives on this subject, please advise. The "search" engine didn't turn up information, or, I don't know how to search properly. The question remains.

Can advancing the t ...

delete I got my forums mixed.

[quote="supercat1"]how often are you supposed to change the oil in the forks?[/quote]

Annually or every 12,000 miles according to the Inspection I and II intervals.

Once you have all t ...

Laminar makes products for the GS series to current year. Check out their website. That said, I see no application for left hand drive roads.

Speed? Earth is traveling 55,000 mph in orbit. W ...

The now discontinued Stradas came off last week, replaced with the next generation Angels. In 11,432 miles, the rear had 3/32nds left and the front had worn but 2/32nds. The main noticeable diffe ...

Thanks for all the information and opinions. I appreciate the responses.

350cc left and 400cc right, Silkolene synthetic 10W. Wow! The forks now work better with the rear Ohlins.

Note: O ...

With some reluctance (I prefer to keep the RS reasonably stock), I ordered the Laminar for my SE. It arrived promptly, was installed easily and looked functional. I waited 24 hours for the dual lo ...

This was a routine drain and refill.

I see nothing in my manual to suggest otherwise, however, I pose this question to the forum -- Does the SE series with Marzocchi fork specify a different quantity of oil? I put 350cc left and 400c ...

How is idle speed adjustment accomplished? K1100RS

I've used a vacuum gauge go synch the idle bleed screws but can't get idle speed below 1,250 rpm. Thanks for responses.