K11 Owners Group

Runs good, 66k miles, Corbin seat, new front tire. Includes cover. Asking $2100 OBO. Fresh fluids in final drive, transmission, oil and brakes. New front brake hoses and fittings.

520 615-405 ...

Got it from Ironhorse. I'd prefer not to have to get back into the gas tank anytime soon......

Cheers,

MickO

Thanks Drake....will run some fuel injector cleaner through the next couple tanks...

Also, after Mick's visit, decided to put a firm surface down the middle of my drive as it's hazardous to bikes w ...

First, many thanks to Drake and Mick for all their help.

Took the fuel pump out and soaked it in fuel injector cleaner. Each morning I'd dry it out a bit and try it.....nothing for the first few d ...

Many thanks to Mick for personal assistance lended yesterday. Hopefully, he's enjoying chocolate as the storms descend on Tucson....

Cheers,

MickO

Thanks...I'll give that a try first....Do I have to disconnect the gas tank to get at the wires?

On testing the fuel injector, do I connect the positive wire to the battery and the negative lead to ...

I have a two prong plug-in connector hooked to the fuel injector. I don't see any yellow/gray wires. The two prong connector is labeled +/-. I did connect that to the negative and the positive to t ...

In the process of removing the fairing, I unhooked the fuel line and a small amount came out, so fuel was reaching the delivery arm. However, when I turned the power on, the fuel pump cycled once but ...

I tested the fuel injector with the LED and got no light. I tried testing it all by itself with the power on as well as with the positive hooked to the battery. Still no light.

I'm in the process ...

Tomorrow I will remove the fairing and test the fuel injector (time permitting) with the LED.

Regards,

Mick

Thanks...

Most likely since when I removed the fuel line, there were parts in the gas tank and the line was cracked and dry when removed. Twill be my next project. Maybe start tomorrow. Thanks ...

Hello,

Tried the LED and got nothing but a solid light. Tried it a few times with the positive to the battery and the negative to the line 1 opening.....

Thoughts???

I haven't tried disconnecting the kickstand shutoff.....don't really know how. When I drop the kick stand down, I can't even get the dash lights to come on so it seems to be working. However, I'd be ...

Hi,

In the html that was linked, it said that for K bikes, an LED is not required and that the codes display on the temperature meter on the dashboard.

If so, would I just connect a length of wi ...

Thanks. That's the next thing I'll try.....

Mick

Thanks to whoever sent the schematic.....I went to the blue connector on the left side above the battery - found it but it's not connected to anything!

I can't even find a 3 pin connector that migh ...

Greetings,

I'm a newbie and first and foremost, many thanks to Flying Duck for his over the phone help and introduction to this forum. I'm in Tucson, Arizona.

I have a 1994 K1100 LT which up un ...