| View previous topic :: View next topic |
| Author |
Message |
LordGondor
Big Brick Rider
Joined: 19 Jan 2007
Posts: 58
Location: Bernardsville, NJ
|
 Posted: Mon Mar 16, 2009 10:54 pm Post subject: Where do you ground the bike to clear codes? |
 |
|
I was trying to clear the stored Mototronic codes by grounding pin 2 of the diagnostic connector. Instead I triggered the dreaded ABS blinking lights. It took me forever to clear the ABS lights error the last time 2 years back. I tried grounding to anything on the bike large and metal but nothing happened. Where do you all ground the connector to? How long do you hold it? How do I clear the Mototronic codes if it's not using pin 2?
Thanks much. Ugh!!
Beau
_________________
93 K1100RS
60K miles now. 30K by me. |
|
| Back to top |
|
 |
Jim
Site Admin
Joined: 17 May 2003
Posts: 3841
Location: WHERETHEFUNNEVERENDS
|
| Posted: Mon Mar 16, 2009 11:05 pm Post subject: |
|
|
Beau - you should be able to ground to just about any bolt in the frame...
The second forum (right under Tech) is Tech Resources & Stickies - has tech tips - including clearing codes. Check that section out, see if you can find any help there.
_________________
Jim
1997 K1100LTSE 94,000 - still has gremlins!
1995 R100RT Classic 16,650 crashed - repaired!
1992 K75RTP 46,000
"We shall not all die, but we shall all be changed." |
|
| Back to top |
|
|
LordGondor
Big Brick Rider
Joined: 19 Jan 2007
Posts: 58
Location: Bernardsville, NJ
|
| Posted: Tue Mar 17, 2009 7:11 am Post subject: |
|
|
DOH! Yep there are the instructions. Thanks Jim.
_________________
93 K1100RS
60K miles now. 30K by me. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
