| View previous topic :: View next topic |
| Author |
Message |
drikko Flying Brick Rider
Joined: 20 Nov 2009 Posts: 1966 Location: Brisbane, OZ
|
Posted: Mon Feb 01, 2010 1:00 am Post subject: Air filter change |
|
|
So even with the tank off, I couldn't see how to get the air filter box apart enough to change the air filter. I even swore at it as only a good aussie boy can do....I called it a kiwi....
SO what's the trick to swapping that f^&ker out????
 _________________ K1100RS '97
Laverda RGS 1000 '84
Jim Young Trailer Sailer 5.7M WB
DISCLAIMER:- Anything I say may have been when I was drunk so please don't take it personally.
'Bigamy is having one wife/husband too many. Monogamy is the same.'
Oscar Wilde |
|
| Back to top |
|
 |
Jim Site Admin

Joined: 17 May 2003 Posts: 3841 Location: WHERETHEFUNNEVERENDS
|
Posted: Mon Feb 01, 2010 1:11 am Post subject: air filter swap |
|
|
drikko - I can't honestly say if it's the same on the RS. On the LT, after you undo the hooks that hold the top on, you can raise the top just enough to slide the filter out. If you drop one of those hooks, they're a pain to get back on. _________________ Jim
1997 K1100LTSE 94,000 - still has gremlins!
1995 R100RT Classic 16,650 crashed - repaired!
1992 K75RTP 46,000
"We shall not all die, but we shall all be changed." |
|
| Back to top |
|
 |
Geoff Flying Brick Rider

Joined: 08 Feb 2007 Posts: 551 Location: Illinois
|
Posted: Mon Feb 01, 2010 10:20 am Post subject: |
|
|
My manual says to detach the right side section of the fairing. Is this necessary? _________________ 2000 R1100RT
2008 H-D Electra Glide Ultra Classic |
|
| Back to top |
|
 |
Phil Marvin Rider in the Sky
Joined: 03 Apr 2003 Posts: 1389 Location: El Paso, Texas, USA
|
Posted: Mon Feb 01, 2010 3:58 pm Post subject: |
|
|
| Geoff wrote: | | My manual says to detach the right side section of the fairing. Is this necessary? |
To replace air filter on a K1100:
1. remove right side crash bar (K1100LT) and fairing.
2. remove air intake horn.
3. unclip air filter housing (2 at rear, 1 at front) A couple of curse words are sometimes helpful.
4. raise housing as high as possible (maybe as much as 1/4")
5. remove old air filter. Many curse words are sometimes helpful.
6. reinstall new (or old, cleaned) air filter. MAKE SURE you install it the correct way - the left side bottom does not have a ridge so you can slide it all the way onto the housing.
7. Fit the top housing onto the filter. Reinstall clips. Many curse words are usually uttered here.
8. Reinstall intake air horn, right side fairing and crash bar.
9. Ride.
NOTE: Notice, I never said anything about removing or even raising the fuel tank. _________________ Ride Safe,
Phil Marvin in El Paso, TX
'94 K75A/3
'95 K75RTP |
|
| Back to top |
|
 |
Mystic Red Flying Brick Rider

Joined: 28 Mar 2005 Posts: 2330 Location: Twin Lakes Idaho
|
Posted: Mon Feb 01, 2010 4:47 pm Post subject: |
|
|
| Quote: | | 1. remove right side crash bar (K1100LT) and fairing. |
I have never done this. All I do is the side panel and knee pad. May be easier Phil's way though.
| Quote: | | 4. raise housing as high as possible (maybe as much as 1/4") |
Why didn't they make this a side entry deal?  _________________ Scott Hespelt, '94 K11LT
K11 OG #466 |
|
| Back to top |
|
 |
drikko Flying Brick Rider
Joined: 20 Nov 2009 Posts: 1966 Location: Brisbane, OZ
|
Posted: Mon Feb 01, 2010 6:54 pm Post subject: |
|
|
Thanks for that, it was probably hitlers little joke on all of us.... _________________ K1100RS '97
Laverda RGS 1000 '84
Jim Young Trailer Sailer 5.7M WB
DISCLAIMER:- Anything I say may have been when I was drunk so please don't take it personally.
'Bigamy is having one wife/husband too many. Monogamy is the same.'
Oscar Wilde |
|
| Back to top |
|
 |
beemeerr11 Flying Brick Rider
Joined: 05 Mar 2006 Posts: 168
|
Posted: Mon Feb 01, 2010 10:47 pm Post subject: |
|
|
| drikko wrote: | | Thanks for that, it was probably hitlers little joke on all of us.... |
Phils way is correct, and I find a steel ruler helps the whole thing.
Lou
95LT (Aus) |
|
| Back to top |
|
 |
2xcelr8 Big Brick Rider
Joined: 29 Sep 2009 Posts: 71 Location: SE Wisconsin
|
Posted: Mon Feb 01, 2010 10:58 pm Post subject: RS Filter |
|
|
I had trouble lifting the lid high enough on my RS without removing the insulation between the frame and the lid. Yes, curse words magically start flowing when the clip seperates from the air box and of course it will be the one you can see the mount to put it back. _________________ Doug
'96 K1100RS, '94 K1100LT, '84 Honda VF700F Interceptor (4 sale) |
|
| Back to top |
|
 |
Flying Duck PsyKotic Waterfowl

Joined: 27 Jan 2005 Posts: 10102 Location: Bumf***, WA
|
Posted: Mon Feb 01, 2010 11:36 pm Post subject: |
|
|
If you look closely at the filter then you'll see it doesn't have a ridge on the inside top. Put that side in first. _________________ 93 LT (x2)
94 RS
86-97 K75F(K75/100/1100 Frankenbrick)
86 K75C w/paralever, hi perf cams,TURBO!
91 & 92 K75Ss
91 K1
86 custom K100
14 WR250R
IBA #17739 (SS1K, BBG, 50CC)
Buy parts HERE |
|
| Back to top |
|
 |
drikko Flying Brick Rider
Joined: 20 Nov 2009 Posts: 1966 Location: Brisbane, OZ
|
Posted: Sat Feb 06, 2010 6:57 am Post subject: |
|
|
Well, just managed to get this done. What a cluster f^ck of a thing that is. I have new neighbours as of a week ago, I suspect they were close to calling the police, their outside lights came on and I could see them looking for what I was swearing at, every word got used to get that f%cker in, f, c, fing c, fing a'hole c, every other combination imaginable, I even resorted to using my recently dear departed grandmothers favourite and only swear word "plurry". I think she heard me....... Lucky my kids were at the ex's house tonight!
I think I'll sell it before that needs doing again!!!!!!!!! _________________ K1100RS '97
Laverda RGS 1000 '84
Jim Young Trailer Sailer 5.7M WB
DISCLAIMER:- Anything I say may have been when I was drunk so please don't take it personally.
'Bigamy is having one wife/husband too many. Monogamy is the same.'
Oscar Wilde |
|
| Back to top |
|
 |
|