K11 Owners Group Forum Index K11 Owners Group
K11 Owners Group
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Rear brake monitor light-93 K11RS-ABS I

 
Post new topic   Reply to topic    K11 Owners Group Forum Index -> Tech
View previous topic :: View next topic  
Author Message
jr'sbmw
Big Brick Rider


Joined: 04 Nov 2008
Posts: 54
Location: Fl

PostPosted: Wed Apr 28, 2010 7:31 pm    Post subject: Rear brake monitor light-93 K11RS-ABS I Reply with quote

A riding buddy installed a new rear tire and started the engine on the center stand, forgetting it was in gear. Now the red rear brake monitor light stays on by the green neutral light, but the red flashing abs light goes out when moving. The owners manual says the rear brake monitor light is a dual function light, checking both the operation of the brake light circuit and abs. The brake light does go on with front and rear brake switch, so that circuit should be ok. On my 97 LT with ABS II, the monitor light goes out when both brakes levers are applied.

We tried clearing the codes with a jumper from #2 wire on the test connector to ground, key on with reset button set for 30 sec. Monitor light still stays on. Purchased a LED to read codes, caused a code, read the code, and removed it, just to make sure the system is working. Zero codes, but the red monitor light is still on!!

Thoughts?
Back to top
View user's profile Send private message
Jim
Site Admin


Joined: 17 May 2003
Posts: 3841
Location: WHERETHEFUNNEVERENDS

PostPosted: Wed Apr 28, 2010 7:39 pm    Post subject: Reply with quote

Change the bulb - make you sure you put in one of the German made ones. I've had the tail light working just fine, but the light on the dash wouldn't go out until I changed the bulb. Haven't had too much luck with bulbs from other parts of the world. I'm sure my K has it's own electrical gremlins...
_________________
Jim
1997 K1100LTSE 94,000 - still has gremlins!
1995 R100RT Classic 16,650 crashed - repaired!
1992 K75RTP 46,000

"We shall not all die, but we shall all be changed."
Back to top
View user's profile Send private message Send e-mail Visit poster's website
jarnbak
Mad Brick Rider


Joined: 18 Jan 2004
Posts: 85
Location: Helsinge,Denmark

PostPosted: Wed Apr 28, 2010 9:03 pm    Post subject: Reply with quote

Remember to check both tail and brake light.If the tail light burn out,
the monitor box will turn the brake light on but at low power(dim).
Regards Palle.
Back to top
View user's profile Send private message
Flying Duck
PsyKotic Waterfowl


Joined: 27 Jan 2005
Posts: 10102
Location: Bumf***, WA

PostPosted: Thu Apr 29, 2010 3:13 pm    Post subject: Reply with quote

The bulb monitor itself had nothing to do with ABS or fault codes. They're just using the "triangle" indicator light for two purposes.

+1 on what Jim said. Good bulbs, clean sockets. A bulb with a weak filament will light up but still make the BMU upset.
_________________
93 LT (x2)
94 RS
86-97 K75F(K75/100/1100 Frankenbrick)
86 K75C w/paralever, hi perf cams,TURBO!
91 & 92 K75Ss
91 K1
86 custom K100
14 WR250R
IBA #17739 (SS1K, BBG, 50CC)
Buy parts HERE
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    K11 Owners Group Forum Index -> Tech All times are GMT - 4 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group