K11 Owners Group - TESTING SITE

by **Flying Duck** » Mon Oct 26, 2009 9:03 pm

How they work

How to adjust them

How to replace the clutch plate and/or O-ring

see here: http://tinyurl.com/fdkclutch

by **Phil Marvin** » Mon Oct 26, 2009 11:51 pm

Hi, Drake,
On the page of the manual showing how to adjust the clutch, there is a typical error. The dimension "A" is given as 4.0mm +/- 0.5mm (1.5748in +/- 0.1968in). The decimal point got moved in the translation. The correct dimension in inches should be 0.15748in +/- 0.01968in.

by **Flying Duck** » Tue Oct 27, 2009 11:39 am

Phil Marvin wrote:Hi, Drake,
On the page of the manual showing how to adjust the clutch, there is a typical error. The dimension "A" is given as 4.0mm +/- 0.5mm (1.5748in +/- 0.1968in). The decimal point got moved in the translation. The correct dimension in inches should be 0.15748in +/- 0.01968in.

I use the mm dimensions and never noticed that. It'd be pretty dang hard to get a 1.6" gap in the clutch lever. :lol:

Thanks. I did some graphic manipulation so it is now correct. (Once I get FrontPage to upload it. Grrr....)

by **whyoldbill** » Thu Mar 11, 2010 12:45 pm

Duck,

Very nice write up! Hats off to you ! If you're ever in the Central Ohio area, please get in touch. Dinner's on me!

Bill

by **Flying Duck** » Thu Mar 11, 2010 3:07 pm

Thanks. Not sure if I'll ever be in Ohio again(been there a few times in the past) but you never know.

K11 Owners Group - TESTING SITE

K bike clutches

K bike clutches

K bike clutches

Who is online