| View previous topic :: View next topic |
| Author |
Message |
Al.
Flying Brick Rider
Joined: 28 Oct 2005
Posts: 397
Location: West of Ireland
|
 Posted: Wed Jul 17, 2024 9:05 am Post subject: Water pump |
 |
|
All assembled but it's quite stiff to turn.
Because of both new seals I didn't expect it to be free but
it is stiff.
Fitted a new pump shaft.
Stiil on the bench until I clean off block.
Comments please.
I don't think seal had failed, the two top
bolts on the pump body were loose.
_________________
1994 K1100 LTSE + Blackbird |
|
| Back to top |
|
 |
kirkkw
Big Brick Rider
Joined: 11 Jan 2004
Posts: 67
Location: Near Austin Tx
|
| Posted: Sat Jul 20, 2024 1:02 pm Post subject: |
|
|
Where did you purchase parts to rebuild the water pump?
_________________
1996 K1100RS, 1976 CB750A, 2017 Triumph Trophy, 2020 R1250RT, 2022 RE Classic 350 |
|
| Back to top |
|
|
Al.
Flying Brick Rider
Joined: 28 Oct 2005
Posts: 397
Location: West of Ireland
|
| Posted: Mon Jul 22, 2024 2:16 pm Post subject: |
|
|
Initially from kpartsholland but even though it said new on invoice, it wasn't.
I sent it back but only got refund for part, not for postage, arguing the point now.
Got new one from Motorworks.
_________________
1994 K1100 LTSE + Blackbird |
|
| Back to top |
|
|
Al.
Flying Brick Rider
Joined: 28 Oct 2005
Posts: 397
Location: West of Ireland
|
| Posted: Tue Jul 23, 2024 4:38 pm Post subject: |
|
|
Ran it today.
It leaked initially, read that elsewhere, but after
a short run it sealed.
_________________
1994 K1100 LTSE + Blackbird |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
