K11 Owners Group

[windcaper]

Okay new issue. I was out for a joy ride today, and noticed that my abs fault lamps lit up. I turn off the bike and after a short while they come on again. I did this a few times, and noticed that they fault without use of the brakes, could it be a voltage problem??? Every time I post a question here I get a good group of responses that usually save me coin, so I thought I would give it a whirl.

Thanks for any help anyone can give.
_________________
1996 K1100 RS SE

[Mystic Red]

Have you read this thread. It will help diagnose ABS as well as a host of other problems and requires little cost in equipment.

http://www.k11og.org/forum/viewtopic.php?t=2110

ABS-I Fault Codes:
Connect the test LED (+lead to Battery + and -lead to Pin#2)
Ignition ON.
The LED will flash a number of times ONLY if there is a fault code stored. Count these short flashes to determine the ABS fault that is stored in the ABS Control Unit.

Code Fault
1 Front Pressure Modulator
2 Rear Pressure Modulator
3 Front Wheel Speed Sensor
4 Rear Wheel Speed Sensor
5 Low Battery Voltage
6 Large blue ABS Relay in the relay box(Not the smaller blue ABS warning relay)
7 ABS Control Unit Defective
8 Possible Wheel Speed Sensor Gap Fault

or

ABS-II Fault Codes

Code Fault
3 Front Wheel Speed Sensor
4 Rear Wheel Speed Sensor
5 Low Battery Voltage
6 ABS Relay in ABS Hydro Unit
7 Control Unit (mounted to side of Hydro Unit)
8 External Influence or Wheel Sensor Gap Incorrect
9 Unknown
12 Piston Fault (This can be Mechanical or Electronic in nature)
_________________
Scott Hespelt, '94 K11LT
K11 OG #466